Q. Which of the following conditions would be most likely to cause strong, interfering surface waves?

Related MCQs

Q. Molarity is defined as the number of gm moles of solute per __________ of solvent.

Q. The barrel is used for the opening and closing of the mold.

Q. The direct-on-line starter is used to start a small dc motor because it limits initial current drawn by armature circuit.

Q. Name the process used to eliminate impurities present in crude oil?

Q. Fouling factor for a heat exchanger is given by (where, U1 = heat transfer co-efficient of dirty surface U2 = heat transfer co-efficient of clean surf

Q. A screw is said to be over hauling screw, if the

Q. Boiling range of kerosene is

Q. Which of the following can be magnetised?

Q. The amount of steam required per unit quantity of distillate in case of steam distillation will be reduced by

Q. For butt welding of two plates, each of which is 300 cm thick, the best process would be