Q. The 100 mm radius in an IIW block is used to:

  • (A) Calibrate sensitivity level
  • (B) Check resolution
  • (C) Calibrate angle beam distance
  • (D) Check beam angle
💬 Discuss
✅ Correct Answer: (C) Calibrate angle beam distance

Published by Mr. Dubey ⭐ 111.54K Points at 21-Sep-2023 07:19 pm in Non Destructive Testing and Evaluation

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. The work done in compressing 1 kg of air in compression will be least when the value of index is

Q. Bonding element in a strain gauge must have

Q. During the manufacturing of a casting, the purpose of a riser is:

Q. How does outside air enter into the wet cooling system?

Q. Laboratory determination of the diffusivity of vapor is done by __________ method.

Q. A block of wood and a block of metal feel equally cold or equally hot when touched. Then their common temperature is

Q. A bullet is fired vertically upwards with a velocity of 2200 ft/s. Bullet ascends to a height of

Q. Which of the following methods is not recommended for pre-cleaning prior to a liquid penetrant test:

Q. The radial distance from the top of a tooth to the bottom of a tooth in a meshing gear, is called

Q. Out of the following four assumptions used in the derivation of the equation for LMTD [LMTD = (∆t1 - ∆t2)/ln(∆t1/∆t2)], which one is subject t

📊 Question Analytics

👁️
579
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
91%
Success Rate