Q. Radiographic film speed can be increased by using:

  • (A) A higher mA setting
  • (B) A lower mA setting
  • (C) A double emulsion versus a single emulsion film
  • (D) Lead screens versus fluorescent screens
💬 Discuss
✅ Correct Answer: (D) Lead screens versus fluorescent screens

Published by Mr. Dubey ⭐ 104.82K Points at 21-Sep-2023 07:20 pm in Non Destructive Testing and Evaluation

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. Electrical strain gauge works on the principle of

Q. A magnetic particle testing technique in which the test piece is magnetised and magnetic particles applied after the magnetising force has been remove

Q. Which of the following defects occur when the deposited metal is not focused on the root of weld?

Q. When a drain-dwell technique is used during emulsification, what two mechanisms are responsible for combining the emulsifier and penetrant?

Q. A block representation can be portrayed by ________,which demonstrates how blocks are nested into one another.

Q. What method provides greater sensitivity, particularly in locating subsurface discontinuities?:

Q. The diameter of the rivet hole is usually __________ the nominal diameter of the rivet.

Q. Polymerisation is a chemical process in which molecules of a compound become

Q. When two forces acting at a point are such that if the direction of one is reversed, the direction of the resultant is turned through a right angle, t

Q. The data bus buffer is controlled by

📊 Question Analytics

👁️
540
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
87%
Success Rate