📊 Process Planning and Cost Estimation
Q. In type of manufacturing process, material is wasted. It is in the form of chips.
  • (A) machining process
  • (B) casting process
  • (C) joining process
  • (D) forming and shaping process
💬 Discuss
✅ Correct Answer: (A) machining process

Explanation: in machining process, some raw material is wasted in or in order to perform different operations like drilling, turning etc.

Explanation by: Mr. Dubey
in machining process, some raw material is wasted in or in order to perform different operations like drilling, turning etc.

💬 Discussion

Related MCQs

Q. A continuous linear indication along the edge of a new fillet weld would most likely be a:

Q. The statement "The most probable value of an observed quantity available from a given set of observation is the one for which the sum of the squa

Q. Which of the following is considered as the noble gas?

Q. If a spark plug does not fire, the probable cause could be

Q. To indicate the position of the workpiece ly & easily machine zero pint should be displaced to another point on the workpiece called…

Q. Which of the following requirement is satisfied by a phase change of the first order?

Q. At vena contracta the velocity is _________ and pressure is ___________

Q. Orifice Meter can only be used for measuring rate of flow in open pipe like structure.

Q. A single ply leather belt running at a belt velocity of 300 ft/min is likely to transmit per inch of width

Q. Occurrence of 'case hardening' during drying of a high moisture solid cake __________ the drying rate.

📊 Question Analytics

👁️
996
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
81%
Success Rate