M

Mr. Dubey • 100.64K Points
Coach

Q. Taper boring and the under boring can be performed by

  • (A) centers
  • (B) face plates or angle plates
  • (C) special attachments
  • (D) none of the mentioned
Share
Explanation by: Mr. Dubey
both types of plates can be used for this purpose. a face plate consists of a circular disk bored out and threaded to sit the nose of the lathe spindle while angel plate

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. Which of the following is an open thermodynamic system?

Q. The specific gravity of diesel oil is closer to

Q. The density of water is maximum at

Q. The term that is used for geometric modelling like solid modelling, wire frame modelling and drafting is known as

Q. The term is used to refer to the product of wave velocity and density is:

Q. The desire to apply the computerin more and more applications led to its being used in increasingly less under-stood and more -----------------

Q. In order to avoid tearing of the plate at edge, the distance from the center line of the rivet hole to the nearest edge of the plate in terms of dia.

Q. Stirling boiler is an example of which type of boiler?

Q. A shunt motor runs at 500rpm on a 200V circuit. Its armature resistance is 0.5Ω and the current taken is 30A in addition to field current. What

Q. In regenerative feed heating system the steam 'bled' from turbine exchanges heat with

Question analytics