M

Mr. Dubey • 100.64K Points
Coach

Q. Which of the following represents the formula for the depth of cut? d1=diameter of work surface before machining and d2=diameter of the machined surface

  • (A) d1+d2
  • (B) d1-d2
  • (C) (d1+d2)/2
  • (D) (d1-d2)/2
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. Carburizing is done

Q. Mark the wrong option. Which of the following cause and effect behaviour in speed control is correct when field resistance is increased.

Q. In the below given voltage controller circuit

Q. How many percentage of fissionable U-235 occurring in uranium?

Q. Dwell is the time

Q. A generating station is to supply four regions of loads with peak demands of 10 MW, 15 MW, 20 MW and 30 MW. If the diversity factor is 1.5 the maximum

Q. Diesel locomotives in India are manufactured at

Q. The distribution of the forces along the length of key fitted in a shaft

Q. Heat transfer occurs by natural convection because change in temperature causes difference in

Q. How many measurement parameters are considered in checking axes accuracy of straightness in CMM?

Question analytics