Q. Brazing is a type of metal joining process.

  • (A) true
  • (B) false
  • (C) ---
  • (D) ---
💬 Discuss
✅ Correct Answer: (A) true
Explanation: it is a metal joining process. it joints the metal by melting and flowing a filler metal into the joint. the adjoining metal has higher melting point compare to filler metal.

Published by Mr. Dubey ⭐ 109.99K Points at 23-Sep-2023 07:30 pm in Process Planning and Cost Estimation

Explanation by: Mr. Dubey
it is a metal joining process. it joints the metal by melting and flowing a filler metal into the joint. the adjoining metal has higher melting point compare to filler metal.

💬 Discussion

Related MCQs

Q. The typical causes for false indications are:

Q. LMTD can't be used as such without a correction factor for the

Q. A wet vapour can be completely specified by

Q. When not in use, the self-discharge of an automobile battery in dry weather is usually

Q. A 4 pole, 50Hz , 3 phase I M is running at 1425rpm on full load having rotor impedance per phase on standstill as 0.4+j2Ω. The external resistan

Q. Which technique is the most sensitive?

Q. In a ball bearing, ball and bearing forms a

Q. In the above problem, acceleration of crooshead at 30o phase equals

Q. following is posted loop?

Q. One kilogram of water at 0°C is changed to superheated steam of one atm pressure and 300° C. The major heat consumption in the process will be

📊 Question Analytics

👁️
430
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
84%
Success Rate