Q. Which of the following is the type of permanent joining process?

  • (A) welding
  • (B) soldering
  • (C) both welding and soldering
  • (D) none of the mentioned
💬 Discuss
✅ Correct Answer: (C) both welding and soldering
Explanation: in welding and soldering, once the join has made, we have to break the joint to get different part. so, both welding and soldering are known as permanent joining process.

Published by Mr. Dubey ⭐ 111.54K Points at 23-Sep-2023 07:30 pm in Process Planning and Cost Estimation

Explanation by: Mr. Dubey
in welding and soldering, once the join has made, we have to break the joint to get different part. so, both welding and soldering are known as permanent joining process.

💬 Discussion

Related MCQs

Q. Which of the following steps detects the key in a 4*4 keyboard matrix about the key that is being pressed?

Q. the direction of rotating magnetic field depends upon

Q. Shot blasting process improves the endurance limit of the component.

Q. For specified tube outside diameter, higher BWG means higher

Q. In case of gases, the binary diffusivity is proportional to (where, P = pressure).

Q. The precess of breaking up or a liquid into fine droplets by spraying is called

Q. The Kelvin temperature is numerically equal to the and may be measured by means of a

Q. In order to achieve maximum possible fuel economy the design features which will be affected are

Q. Stefan Boltzmann law is applicable for heat transfer by

Q. Typical immersion test frequencies for wrought aluminium are:

📊 Question Analytics

👁️
569
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
86%
Success Rate