Q. In which of the following forging metal is kept in the lower die?

  • (A) open die
  • (B) closed die
  • (C) impression dies
  • (D) hold dies
💬 Discuss
✅ Correct Answer: (A) open die
Explanation: when shaping a solid piece of metal by closed die forging, the die is initially open. the work piece is placed in the lower die half, and the top die is then brought down to engage with the work piece the

Published by Mr. Dubey ⭐ 104.82K Points at 23-Sep-2023 07:30 pm in Process Planning and Cost Estimation

Explanation by: Mr. Dubey
when shaping a solid piece of metal by closed die forging, the die is initially open. the work piece is placed in the lower die half, and the top die is then brought down to engage with the work piece the

💬 Discussion

Related MCQs

Q. A jet of water of cross-sectional area 20 sq. cm impinges on a plate at an angle of 60o with a velocity of 10 m/sec. Neglecting the frictio

Q. In a diesel engine a clogged nozzle could result in

Q. In Beizer Curve, the flexibility of the shape would increase with

Q. Gas lubricated bearings are used for

Q. Which of the following furnace is used for steel only?

Q. A tapered key which fits in a key way in the hub and the bottom of which is shaped to fit the curved surface of the shaft, is known as,

Q. Compressed air is required in diesel engine power plants mainly for

Q. There is problem of alignment in deep groove ball bearings.

Q. Which of the following is the process of the pre-processing stage?

Q. At the first critical speed a shaft will

📊 Question Analytics

👁️
382
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
90%
Success Rate