📊 Process Planning and Cost Estimation
Q. The main parts of shaper are
  • (A) base and body
  • (B) ram and tool head
  • (C) crossrail and body
  • (D) all of the mentioned
💬 Discuss
✅ Correct Answer: (D) all of the mentioned

Explanation: all mentioned are the parts of shaper. due to these parts, this machine is arranged in such a manner that it can produce flat surfaces easily and perform other operations too.

Explanation by: Mr. Dubey
all mentioned are the parts of shaper. due to these parts, this machine is arranged in such a manner that it can produce flat surfaces easily and perform other operations too.

💬 Discussion

Related MCQs

Q. When the pressure chamber is big, the flow velocities are

Q. A taper bearing has

Q. The discharge of hydrocarbons from an automobile exhaust is minimum when the vehicle is

Q. Steady state equimolal counter diffusion occurs in case of

Q. What action is necessary if the penetrant is inadvertently allowed to dry on the test piece?

Q. Plastic collosion of two bodies of equal mass results in a common velocity after impact which is

Q. Which company is not engaged in the manufacture of tyres in India

Q. Surface models are used mostly in

Q. The piston rod of a steam engine is usually connected to the cross-head by means of

Q. All of the following plants are suitable for peak load EXCEPT

📊 Question Analytics

👁️
672
Total Visits
📽️
2 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
93%
Success Rate