R

Ram Sharma • 193.88K Points
Coach

Q. In a shell and tube heat exchanger, the shortest centre to centre distance between the adjacent tubes is

  • (A) Called tube pitch
  • (B) Called tube clearance
  • (C) Always less than the diameter of the tube
  • (D) None of these
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. If oxygen content in the flue gas rises too high, fuel is being wasted by

Q. Construction expenses are roughly _________ percent of the total direct cost of the plant.

Q. Minimum tube pitch recommended for shell and tube heat exchangers is about __________ times the outside diameter of the tube.

Q. Response of a linear control system for a change in set point is called

Q. The gas which contributes maximum to the heating value of natural gas is

Q. In a 1-1 cocurrent heat exchanger, if the tube side fluid outlet temperature is equal to the shell side fluid outlet temperature, then the LMTD is

Q. Cd for the orifice plate varies from

Q. Fatigue resistance of a material is measured by the

Q. Ceramic materials are

Q. Which of the following is not a continuous waste heat recovery equipment from the flue gases going out of furnace?

Question analytics