Q. For the brake to be self locking, the force P at C shown in the below figure, should

Related MCQs

Q. In compression molding, the curing time does not depend on which of the following factors?

Q. The load cup of a screw jack is made separate from the head of the spindle to

Q. The critical pressure at which latent heat of vaporisation is zero is

Q. When two pulleys of different diameters are connected by means of an open belt, the angle of contact at the ________ pulley must be taken into conside

Q. When a bolt is subjected to an external load, the stress induced in the bolt will be

Q. Above the curie temperature, a magnetic material becomes

Q. Energy efficiency of superficial steam is _________

Q. In which operation the horse power required to remove one cubic centimetre of material (soft steel) per minute under average conditions will be maximu

Q. A man pulls a cart with 100 N force from rest with an acceleration of 10 m/sec2 for 10 seconds. The work done by him is

Q. A cumulatively compounded motor does not run at dangerous speed at light loads because of the presence of ______.