Q. The length of straight rectangular weir used on cross-flow trays is generally __________ the column diameter.

  • (A) 0.6-0.8 times
  • (B) Equal to
  • (C) Twice
  • (D) 2 ft irrespective of (for column > 3 ft diameter)
💬 Discuss
✅ Correct Answer: (A) 0.6-0.8 times

Published by Ram Sharma ⭐ 193.88K Points at 06-Jul-2023 07:45 am in Process Equipment And Plant Design

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. Coke oven regenerators are made of __________ bricks.

Q. Char value of Kerosene is the amount of charred oil deposition on the wick obtained after burning ti in a standard wick lamp at a standard rate for 24

Q. In case of wet spinning of polymers, the polymer solution is forced through spinnerates into, a coagulating bath to give a filament form. Wet spinning

Q. Boiling point elevation for a strong and concentrated solution is found by Duhring's rule, which states that at the same pressure, the boiling point o

Q. Water content in the crude oil as it comes out of oil well may be upto _________ percent.

Q. The heat transfer by radiation from a mild steel surface is to be reduced by reducing the emissivity of the surface. This can be best achieved by

Q. _________ are normally subjected to sub-zero treatment.

Q. Pressure of 0.01 psi (absolute) can be measured by __________ gauge.

Q. Which of the following accounts for the maximum energy release in the nuclear fission process?

Q. In a heat exchanger, one transfer unit means

📊 Question Analytics

👁️
430
Total Visits
📽️
3 y ago
Published
🎖️
Ram Sharma
Publisher
📈
80%
Success Rate