📊 Machine Design
Q. Set screws are
  • (A) Similar to small size tap bolts except that a greater variety of shapes of heads are available
  • (B) Slotted for a screw driver and generally used with a nut
  • (C) Used to prevent relative motion between parts
  • (D) Similar to stud
💬 Discuss
✅ Correct Answer: (C) Used to prevent relative motion between parts

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. Moisture in a substance exerting an equilibrium vapour pressure less than that of pure liquid at the same temperature is called the __________ moistur

Q. In sub-cooled boiling,

Q. Which of the following is a likely effect of a rough test piece surface?

Q. Calculate the diameter of pin from shear consideration with maximum shear stress allowed is 40NN/mm² and an axial tensile force of 50kN is acting

Q. When considerable material must be removed to clean up a cylinder bore, the cylinder should be

Q. Which of the following represents the formula for the depth of cut? d1=diameter of work surface before machining and d2=diameter of the machined surfa

Q. The ratio of pitch circle diameter in millimeters to the number of teeth, is called

Q. Hard steels and non-ferrous metal do not exhibit a definite yield point when pulled in the testing machine and for such cases a better measure of thei

Q. 1000 kg of wet solids are to be dried from 60% to 20% moisture (by weight). The mass of moisture removed in kg is

Q. Which one of the following is independent of fuel constituents, combustion chamber design, temperature and pressure of compressed charge

📊 Question Analytics

👁️
397
Total Visits
📽️
2 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
93%
Success Rate