📊 Machine Design
Q. The permissible stress in the fillet weld is 100 N/mm². The fillet weld has equal leg lengths of 15 mm each. The allowable shearing load on the weldment per cm length of the weld is
  • (A) 7.5 kN
  • (B) 10.6 kN
  • (C) 15 kN
  • (D) 22.5 kN
💬 Discuss
✅ Correct Answer: (B) 10.6 kN

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. The total hardness of the potable water should be less than

Q. The software that is used to control the computer’s work flow, organize its data and perform housekeeping functions is known as

Q. The gamma factor of Co-60 is:

Q. A graph between __________ is called Wilson plot.

Q. The torque of 50 Nm is applied on the wheel operating a valve. If the wheel is rotated through two revolutions, work done in Newton-metres is given by

Q. In inertia friction welding energy of welding machine is used.

Q. The power supplied to domestic consumers is at 220 volts. This represents

Q. The engine of an aeroplane rotates in clockwise direction when seen from the tail end and the aeroplane takes a turn to the left. The effect of gyrosc

Q. Statement 1: Freezing with nitrogen or carbon dioxide gas is rapid freezing. Statement 2: Super cooling is a property of food products.

Q. In which of the following processes the external work done is not zero?

📊 Question Analytics

👁️
180
Total Visits
📽️
2 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
87%
Success Rate