📊 Machine Design
Q. The width of the pulley should be __________ width of the belt.
  • (A) Equal to
  • (B) Less than
  • (C) Greater than
  • (D) None of these
💬 Discuss
✅ Correct Answer: (C) Greater than

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. In a diesel engine the pipe carrying fuel from fuel pump to nozzle is made of

Q. Under force-current analogy, viscous friction coefficient is considered analogous to

Q. A coarse scres of major diameter 6 mm is designated as

Q. The expression (A2-A1)/loge (A2/A1) for a hollow cylinder is known as

Q. The temperature in a dry bottom pulverised coal furnace, in degree Celsius is about?

Q. If air resistance is neglected, at the mid-point of its swing, the acceleration of the bob of a simple pendulum along its path is always

Q. ABCD is a four bar mechanism in which AB = 310 mm and CD = 450 mm. AB and CD are both perpendicular to the fixed link AD, as shown in the below figure

Q. An aqueous solution of methanol is to be distilled in a tray column. High pressure steam is available as a source of heat. For a given reflux ratio an

Q. A car travelling at a speed of 60 km/hour is braked and comes to rest 6 seconds after the brakes are applied. The minimum coefficient of driction betw

Q. A pure substance which exists in a single phase has independent variables.

📊 Question Analytics

👁️
258
Total Visits
📽️
2 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
88%
Success Rate