M

Mr. Dubey • 100.64K Points
Coach

Q. The divergent portion of a Venturimeter is made longer than convergent portion in order to

  • (A) Avoid the tendency of breaking away the stream of liquid
  • (B) To minimise frictional losses
  • (C) Both (A) and (B)
  • (D) None of these
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. The commonly used solvent in oil paints is ?

Q. The direct cost of a project with respect to normal time is

Q. The rivets which are driven at atmospheric temperature, are known as ?

Q. The compressive strength of a good Portland cement and standard sand mortar after 3 days of curing should not be less than ?

Q. According to the recommendations of IS : 456-1978, the expansion joints

Q. Which types of vertical loads applies on the caissons?

Q. The number of sleepers used for rail varies from ?

Q. Centrifugal pump is a turbomachinery.

Q. If the 20 mm rivets are used in lacing bars, then the minimum width of lacing bar should be

Q. Under which of the following conditions the closure of valve is considered rapid? (where L = length of pipe, C = velocity of pressure wave produced du

Question analytics