📊 Thermal Engineering
Q. A wet vapour can be completely specified by
  • (A) pressure only
  • (B) temperature only
  • (C) dryness fraction only
  • (D) pressure and dryness fraction.
💬 Discuss
✅ Correct Answer: (D) pressure and dryness fraction.

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. If the pressures at the beginning and end of compression in an Otto cycle engine are 1 kg/cm2 and 8 kg/cm2 respectively the air standard efficiency wi

Q. is prepared on the basis of plinth area of building, the rate being deducted from the cost of similar building having similar specification, heights a

Q. The available energy is known as and the unavailable energy is known as

Q. Critical pressure ratio is ratios of pressures at _________ discharge.

Q. What is the lamination used for the stator?

Q. A wall has two layers of materials A and B; each made of a different material. Both the layers have the same thickness. The thermal conductivity of ma

Q. Which of the following is a pendulum type governor?

Q. How is water circulated throughout the dry cooling tower system?

Q. When a gas is pushed through a pipe, the gaseous molecules are by the pipe’s walls

Q. A thin cylinder contains fluid at a pressure of 30 kg kg/cm2, the internal diameter of the shell is 60 cm and the tensile stress in the material is to

📊 Question Analytics

👁️
159
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
93%
Success Rate