📊 Automobile Engineering
Q. To avoid chances of maisalignment the bearing generally used is
  • (A) Double row ball bearing
  • (B) Axial bearing
  • (C) Self-aligning bearing
  • (D) Taper roller bearing
💬 Discuss
✅ Correct Answer: (D) Taper roller bearing

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. Rankine Gordon formula for buckling is valid for

Q. In a flat belt drive, if the slip between the driver and belt is 1%, between the belt and follower is 3% and driver and follower pulley diameters are

Q. In stress relief annealing, the annealing temperature is relatively low.

Q. Which of the following given below as the affect on amount natural draught?

Q. The air standard efficiency of a turbine cycle is 56.5%, which one of the following may be Carnot efficiency between the temperature limits of the cyc

Q. Which of the following statement is correct?

Q. Which of the following represents the unit of metal removal rate?

Q. The radiation from 37 GBq (1 Ci) of Co-60 (0.145 Gy or 14.5R at 30.5 cm or 1 foot) is attenuated in air to approximately 5mR/h at a distance of approx

Q. In case of clutch if the springs become weak, the remedy lies in

Q. In a hydrodynamic journal bearing, there is

📊 Question Analytics

👁️
409
Total Visits
📽️
1 y ago
Published
🎖️
Vinay
Publisher
📈
94%
Success Rate