📊 Irrigation Engineering
Q. The sensitivity of an outlet is defined as the ratio of the ?
  • (A) rate of change of discharge of an outlet to the rate of change of discharge of the distribution channel
  • (B) rate of change of discharge of an outlet to the rate of change in level of the distribution surface, referred to normal depth of the channel
  • (C) depth of the sill or the crest level of the module below the full supply of the distribution channel to the full supply depth of the distributing channel
  • (D) head recovered to the head put in an outlet
💬 Discuss
✅ Correct Answer: (B) rate of change of discharge of an outlet to the rate of change in level of the distribution surface, referred to normal depth of the channel

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. Distribution of loads on the wall is not uniform in single joist timber floor.

Q. Permanent magnets are made of high carbon steel and

Q. The coefficient of curvature for a well graded soil, must be between

Q. For undistributed samples is used.

Q. A terrain with cross-slope less than 10 percent, is called

Q. The proportion of lime, silica, alumina and iron oxide in a good Portland cement should be ?

Q. As per Mohs's scale, the hardnesses of Corundum & Diamond (in that order) ?

Q. Tacking rivets in tension members, are provided at a pitch in line not exceeding

Q. For mass concrete in piers and abutments, the grade of concrete mix used, is ?

Q. The cable for a pre-stressed concrete simply supported beam subjected to uniformly distributed load over the entire span should ideally be ?

📊 Question Analytics

👁️
368
Total Visits
📽️
12 mo ago
Published
🎖️
Shiva Ram
Publisher
📈
80%
Success Rate