Q. If plain bars are used, the area of distribution reinforcement in slabs should not be less than ?

  • (A) 0.12 % of the gross area of concrete
  • (B) 0.15% of the gross area of concrete
  • (C) 0.18% of the gross area of concrete
  • (D) 0.21% of the gross area of concrete
💬 Discuss
✅ Correct Answer: (B) 0.15% of the gross area of concrete

Published by Rakesh Kumar ⭐ 28.44K Points at 23-Feb-2025 04:33 pm in Reinforced Cement Concrete Structures

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. When the length of the weir is less than the width of the stream, there will be contraction of flow at each end. This contraction is known as

Q. The heel divergency recommended for broad gauge tracks by the Indian railways is ?

Q. The under-reamed piles are connected by a beam known as

Q. mark of one litre and weighed. The weight of the liquid is found to be 6.5 N. The specific volume of the liquid will be

Q. Bag filter design is predominantly dependent on gas temperature, as it affects the gas density & viscosity and the selection of filtering material. Th

Q. a _____ is define as a structure which is sunk through ground or water to exclude water and semi fluid material during the process of excavation of fo

Q. The continuous strain, which the concrete undergoes due to application of external loads, is called

Q. The chemical ingredient of cement which provides quick setting property to the cement is

Q. In any closed traverse, if the survey work is correct, then ?

Q. According to IRC recommendations, the width of transverse expansion joint should be ................. extending to full length of slab ?

📊 Question Analytics

👁️
359
Total Visits
📽️
2 y ago
Published
🎖️
Rakesh Kumar
Publisher
📈
83%
Success Rate