Q. If A is the cross-sectional area of an eccentrically loaded column and Z is the section modulus, then bending factor is equal to ?

  • (A) 2A/Z
  • (B) Z/A
  • (C) A/2Z
  • (D) A/Z
💬 Discuss
✅ Correct Answer: (D) A/Z

Published by Kiran Rapria ⭐ 4.26K Points at 23-Feb-2025 04:41 pm in Steel Structures Design

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. The process of turning the telescope of a theodolite over its supporting axis through 180° in a vertical plane, is called ?

Q. For designing masonry components of a structure, seismic forces provision in the design calculation is not necessary for buildings constructed in

Q. The breaking up of cohesion in a mass of concrete is called ?

Q. The rate of change of radial acceleration governs the

Q. Steining is a component of which of the below type of foundation?

Q. A line normal to the plumb line at all points is known as ?

Q. When the ends of the column are faced for bearing over the whole area, the rivets essential to hold the connected members are designed for ...........

Q. the ______ compact soil close to the earth surface only.

Q. If the coefficient of discharge is 0.6, then the discharge over a right angled notch is

Q. The flow in which the particles of a fluid attain such velocities that varies from point to point in magnitude and direction as well as from instant t

📊 Question Analytics

👁️
377
Total Visits
📽️
1 y ago
Published
🎖️
Kiran Rapria
Publisher
📈
87%
Success Rate