Q. The effective length of fillet weld should not be less than ?

  • (A) the size of weld
  • (B) two times the size of weld
  • (C) three times the size of weld
  • (D) four times the size of weld
💬 Discuss
✅ Correct Answer: (D) four times the size of weld

Published by Shiva Ram ⭐ 30.44K Points at 23-Feb-2025 04:41 pm in Steel Structures Design

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. The moment of resistance of an over-reinforced section is determined on the basis of ?

Q. Select the incorrect statement.

Q. A closed tank is completely filled with an oil. If it is made to move with a horizontal acceleration, then the pressure at the back end will be more t

Q. mark of one litre and weighed. The weight of the liquid is found to be 6.5 N. The specific volume of the liquid will be

Q. If the fore bearing of a line is N 26° 35' W, its back bearing will be ?

Q. A vertical wall is subjected to a pressure due to one kind of liquid, on one of its sides. The total pressure on the wall acts at a distance

Q. In performing the works test

Q. In an impulse turbine, the pressure of water both at entering and leaving the vanes, is atmospheric.

Q. In flat slabs, the width of column strip, where drops are not used, is taken as ?

Q. For quality control of Portland cement, the test essentially done is

📊 Question Analytics

👁️
239
Total Visits
📽️
1 y ago
Published
🎖️
Shiva Ram
Publisher
📈
93%
Success Rate