Q. The reinforcement of butt weld ?

  • (A) is ignored in calculating stresses
  • (B) increases efficiency of joint
  • (C) should not exceed 3 mm
  • (D) all of these
💬 Discuss
✅ Correct Answer: (D) all of these

Published by Rakesh Kumar ⭐ 28.44K Points at 23-Feb-2025 04:41 pm in Steel Structures Design

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. In case of turbulent flow of a fluid through a circular tube (as compared to the case of laminar flow at the same flow rate) the maximum velocity is .

Q. The most economical section of a trapezoidal channel is one which has hydraulic mean depth equal to

Q. A fixed point of reference of known elevation is called ?

Q. The maximum particle size of fine aggregate is

Q. A Piezometer tube is used only for measuring

Q. Push pull scarpers works in the team of ……. Scrapers.

Q. have the highest vane angle at inlet (β1 value)?

Q. The internal friction between the ingredients of concrete is minimised by

Q. The value of ruling gradient in hills, as recommended by Indian Roads Congress, is

Q. The absorption of a surface is the product of the __________ of the surface and its absorption coefficient.

📊 Question Analytics

👁️
158
Total Visits
📽️
2 y ago
Published
🎖️
Rakesh Kumar
Publisher
📈
99%
Success Rate