Q. It is required to construct a 2n-to-1 multiplexer by using 2-to-1 multiplexer only. How many of 2-to-1 multiplexers are needed ?

  • (A) n
  • (B) 2^2n
  • (C) 2^(n-1)
  • (D) 2^n-1
💬 Discuss
✅ Correct Answer: (D) 2^n-1

Published by Ravi Shankar ⭐ 4.19K Points at 24-Feb-2025 08:31 am in Digital Electronics and Logic Design

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. Which of the following data structure is not linear data structure?

Q. Delta modulation uses…………bits sample ?

Q. The contains an offset instead of actual address

Q. When a transistor is fully switched ON, it is said to be

Q. Antenna bandwidth can be increased by using__________.

Q. A clipping window has coordinates as A(50,10), B(80,10), C(80,40), D(50,40). A line segment has end coordinates (40,15) and (75,45). What will be the

Q. The link list also contains a list pointer variable called start or ________.

Q. An emitter-follower amplifier has an input impedance of 107 kΩ. The input signal is 12 mV. The approximate output voltage is (common-collector)

Q. If a transistor operates at the middle of the dc load line, a decrease in the current gain will move the Q point ?

Q. In an inside test if number of intersections are ---------------- then point is inside of the polygon. Note : intersection point is not a vertex.

📊 Question Analytics

👁️
987
Total Visits
📽️
2 y ago
Published
🎖️
Ravi Shankar
Publisher
📈
82%
Success Rate