📊 Electronic Devices and Circuits
Q. For holding the drain current constant inspite of large changes in JFET parameters ?
  • (A) Current source bias is used
  • (B) Reverse bias is used
  • (C) Voltage divider bias is used
  • (D) No bias is used
💬 Discuss
✅ Correct Answer: (A) Current source bias is used

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. In 8086 microprocessor , the address bus is bit wide

Q. The 8-Fill Polygon technique will correctly fill the triangle shown below when seeded at the position shown with an X.

Q. A common-gate amplifier is similar in configuration to which BJT amplifier?

Q. The difference between VOH and VIH voltages is known as

Q. A GTO can be represented by two transistors T1 & T2. The current gain of both transistors are α1 and α2 respectively. A low value of g

Q. In viewing transformation maintain relative size an position between clipping window and viewport. ie a point in window Xw, Yw is transformed to Xv, Y

Q. Following are coordinates of clipping window : Lower Left Corner (20,20) and Upper Right Corner (200,200). What is the outcode of point (75,250)?

Q. When the JFET is no longer able to control the current, this point is called the ?

Q. A single phase full bridge inverter for R-L loads needs

Q. In projections non visible lines are represented as __________lines

📊 Question Analytics

👁️
142
Total Visits
📽️
1 y ago
Published
🎖️
Vikash Gupta
Publisher
📈
82%
Success Rate