Q. An ordinary Portland cement when tested for its fineness, should not leave any residue on I.S. sieve No. 9, more than

Related MCQs

Q. If mineral oil is present in mixing water for concrete, it increases strength for a concentration upto 2 percent.

Q. The basic stress in masonry units having height to width ratio of 1.5 may be increased by a factor of

Q. In a grillage footing, the maximum bending moment occurs at the ?

Q. The center of pressure of a surface subjected to fluid pressure is the point

Q. The difference between gross diameter and nominal diameter for the rivets up to 25 mm diameter is

Q. According to Chezy's formula, the discharge through an open channel is (where A = Area of flow, C = Chezy's constant, m = Hydraulic mean depth, and i

Q. The rate of expulsion of pore fluid is directly dependent on the ............. ?

Q. The power produced by the reaction turbine is

Q. For determining the ultimate bearing capacity of soil, the recommended size of a square bearing plate to be used in load plate test should be 30 to 75

Q. Heavy equipment, such as excavating machinery, trucks, dumpers, etc. should be kept away from the excavated sides at a distance not less than the dept