📊 Automobile Engineering
Q. The process of super charging is meant for
  • (A) An instrument for smoke analysis
  • (B) providing air for cooling
  • (C) increasing density of intake air
  • (D) raising exhaust pressure
💬 Discuss
✅ Correct Answer: (C) increasing density of intake air

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. Particles having the same atomic number but different mass unmbers are called

Q. Which of the following combination of processing and preservation techniques works best for smoked products?

Q. In a single threaded worm and worm wheel the number of teeth on the worm wheel is 60. The diameter of the effort wheel is 12 cm and that of load drum

Q. There is no electrical connection between stator and rotor, still power is transffered from stator to rotor through

Q. The speed of rotating field due to rotor currents relative to rotor surface in an induction motor is

Q. Corrosiveness of steam condensate is due to the presence of

Q. The uniform rate of descent is maintained by a brake on the drum which applies the necessary torque of 300 kg-m what additional brake torque is requir

Q. movements?

Q. Maximum heat transfer rate is achieved in __________ flow.

Q. For the case of flow of air past a wet bulb thermometer (air water vapour system), the approximate value of h2/ky .Cz is around

📊 Question Analytics

👁️
653
Total Visits
📽️
3 y ago
Published
🎖️
Ram Sharma
Publisher
📈
96%
Success Rate