M

Mr. Dubey • 100.64K Points
Coach

Q. When a tension member is made of four angles with a plate as a web, the allowance for holes is made as

  • (A) two holes for each angle and one hole for the web
  • (B) one hole for each angle and one hole for the web
  • (C) one hole for each angle and two holes for the web
  • (D) two holes for each angle and two holes for the web
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. if a hammer is raised by stem and allowed to fall by gravity on top of the pile, it is called as ______.

Q. Which factor does not affect the drilling rate?

Q. The recommended value of modular ratio for reinforced brick work is

Q. In a grillage footing, the maximum shear force occurs at the

Q. The main principle of an organisation, is

Q. A beam is defined as a structural member subjected to

Q. What is the full form ISO is?

Q. For the manufacture of Portland cement, the proportions of raw materials used, are

Q. that is developed in the pipe?

Q. Which of the following system is also known as an interlaced system?

Question analytics