M

Mr. Dubey • 100.64K Points
Coach

Q. For the steel member exposed to weather and accessible for repainting, the thickness of steel should not be less than (accepting the webs of Indian Standard rolled steel joists and channels).

  • (A) 4 mm
  • (B) 6 mm
  • (C) 8 mm
  • (D) 10 mm
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. The method of intersection in plane tabling is commonly used for ?

Q. According to Indian Roads Congress, the maximum width of a road vehicle is

Q. The rate of rise or fall of the road surface along its length, is called ?

Q. If the fineness modulus of sand is 3, then the sand is graded as

Q. The type of rolled steel section mainly used as structural members is ?

Q. Which of the following types of soil is transported by gravitational forces?

Q. Compression members composed of two channels back-to-back and separated by a small distance are connected together by riveting so that the minimum sle

Q. The slenderness ratio of a single angle single strut should be less than ?

Q. If the depth of moist sand in a cylinder is 15 cm and the depth of the sand when fully inundated with water is 12 cm, the bulking of the moist sand, i

Q. The maximum number of vehicles can be parked with

Question analytics