📊 Design of Steel Structures
Q. The ratio of plastic section modulus to elastic section modulus
  • (A) is equal to 1
  • (B) is always less than 1
  • (C) is always greater than 1
  • (D) can be less than 1
💬 Discuss
✅ Correct Answer: (C) is always greater than 1

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. Super plasticizers reduce a water requirement in concrete up to……

Q. According to Darcy's formula, the loss of head due to friction in the pipe is (where f = Darcy's coefficient, l = Length of pipe, v = Velocity of liqu

Q. When the rainfall is more, flatter gradients should be provided in the side drains and the road.

Q. The Central Road Research Institute (C.R.R.I.) was started in Delhi, in ?

Q. The voltage of three phase supply____

Q. The outer and inner faces of a rolled steel beam section are inclined to each other and they intersect at a certain angle. This angle of intersection

Q. A = contact area of footing or plate.

Q. The minimum thickness of a steel plate, which is directly exposed to weather and is not accessible for cleaning and repainting, should be:

Q. depend on the friction factor?

Q. If V is the velocity of wind in km/h, the intensity of wind pressure is directly proportional to ?

📊 Question Analytics

👁️
379
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
88%
Success Rate