Q. The cross-section of the flywheel arms is usually

Related MCQs

Q. Which of the following is an advantage of the Green sand molding process used in a foundry?

Q. Absorption factor is defined as (where, S1 = slope of the operating line S2 = slope of the equilibrium curve)

Q. The work done in sliding a block of weight of 50 kg up a plane inclined at an angle of 30^o to the horizontal so that the block is lifted th

Q. The velocity factor for ordinary cut gears operating at velocities up to 12.5 m/s is equal to

Q. Calculate the refracted shear wave angle in aluminium [VS = 0.31cm/microsec] for an incident longitudinal wave of 43.5 degrees in Plexiglas [VL =0.267

Q. Grinding can be performed by

Q. The effort of a Porter governor is equal to (where c = Percentage increase in speed, m = Mass of ball and M = Mass on the sleeve)

Q. When a shaft is subjected to combined twisting moment (T) and bending moment (M), then the equivalent twisting moment is equal to

Q. A technique in which two transducers are used, one on each side of the test piece, is called:

Q. A governor is said to be stable, if the