Q. In a temperature control system, what conversion in signal takes place?

  • (A) digital to analog
  • (B) analog to digital
  • (C) error to digital
  • (D) error to analog
💬 Discuss
✅ Correct Answer: (B) analog to digital
Explanation: in a temperature control system, analog to digital conversion of signals take place. automatic systems don’t understand analog signals as they only take digital inputs in the form of 0 & 1 so we use a analog to digital converter which converts the signal.

Published by Mr. Dubey ⭐ 109.99K Points at 15-Sep-2023 12:42 am in Control System Engineering

Explanation by: Mr. Dubey
in a temperature control system, analog to digital conversion of signals take place. automatic systems don’t understand analog signals as they only take digital inputs in the form of 0 & 1 so we use a analog to digital converter which converts the signal.

💬 Discussion

Related MCQs

Q. What does the beam width of an antenna tell us?

Q. With a D.C. generator which of the following regulation is preferred ?

Q. 15 minute rated motors are suitable for

Q. The speed of a locomotive is controlled by

Q. Interpole flux should be sufficient to

Q. What is the value of M for the constant M circle represented by the equation 8x2+18x+8y2+9=0?

Q. In D.C. generators the polarity of the interpoles

Q. In closed loop control system, with positive value of feedback gain the overall gain of the system will

Q. Low is the G/T ratio of an antenna, higher is its efficiency.

Q. Total resultant field obtained by the antenna array is given by which of following?

📊 Question Analytics

👁️
741
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
96%
Success Rate