📊 Control System Engineering
Q. Addition of zero at origin:
  • (A) improvement in transient response
  • (B) reduction in steady state error
  • (C) reduction is settling time
  • (D) increase in damping constant
💬 Discuss
✅ Correct Answer: (A) improvement in transient response

Explanation: stability of the system can be determined by various factors and for a good control system the stability of the system must be more and this can be increased by adding zero to the system and improves the transient response.

Explanation by: Mr. Dubey
stability of the system can be determined by various factors and for a good control system the stability of the system must be more and this can be increased by adding zero to the system and improves the transient response.

💬 Discussion

Related MCQs

Q. The open circuit voltage of a compound generator is 250 V. At full load the terminal voltage

Q. A class B amplifier consists of transistors in order to conduct the input signal over the entire cycle.

Q. If the gain of the system is reduced to a zero value, the roots of the system in the s- plane,

Q. Magnetic field in a D.C. generator is produced by

Q. In all base driver amplifiers

Q. In case of traveling cranes, the motor preferred for boom hoist is

Q. The use of sampled data control system are:

Q. In a parallel R-C circuit, the current always _________ the applied voltage

Q. In D.C. generators, the brushes on commutator remain in contact with conductors which

Q. Consider a system if represented by state space equation and x1 (t) =x2 (t), then the system is:

📊 Question Analytics

👁️
181
Total Visits
📽️
2 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
85%
Success Rate