Q. A system is said to be if every state can be completely identified by measurements of the outputs at the finite time interval.

  • (A) controllable
  • (B) observable
  • (C) cannot be determined
  • (D) controllable and observable
💬 Discuss
✅ Correct Answer: (B) observable
Explanation: by definition, a system is said to be observable, if every state can be completely identified by measurements of the outputs at the finite time interval.

Published by Mr. Dubey ⭐ 110.47K Points at 15-Sep-2023 12:42 am in Control System Engineering

Explanation by: Mr. Dubey
by definition, a system is said to be observable, if every state can be completely identified by measurements of the outputs at the finite time interval.

💬 Discussion

Related MCQs

Q. A differential amplifier is invariably used in the i/p stage of all OP-AMPs.This is dome basically to provide the OP-AMPs with a very high

Q. The consideration involved in the selection of the type of electric drive for a particular application depends on

Q. Which among the following is a unique model of a system?

Q. In a D.C. generator in case the resistance of the field winding is increased, then output voltage will

Q. In ........the speed can be varied by changing the position of brushes

Q. A current of 16 amperes divides between two branches in parallel of resistances 8 ohms and 12 ohms respectively. The current in each branch is

Q. In a D.C. generator the critical resistance can be increased by

Q. Roots on the imaginary axis makes the system :

Q. For medium duty cranes the short time rating motor used is

Q. The transfer function technique is considered as inadequate under which of the following conditions ?

📊 Question Analytics

👁️
126
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
96%
Success Rate