M

Mr. Dubey • 100.64K Points
Coach

Q. State model representation is possible using

  • (A) physical variables
  • (B) phase variables
  • (C) canonical state variables
  • (D) all of the mentioned
Share
Explanation by: Mr. Dubey
state model representation is the representation of the control system is the form of the state variables and state vectors

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. What is the number of the root locus segments which do not terminate on zeroes?

Q. technique is not applicable to nonlinear system ?

Q. Conduit pipes are normally used to protect _________ cables.

Q. A system is said to be_________________ if every state can be completely identified by measurements of the outputs at the finite time interval.

Q. How is the sampling rate conversion achieved by factor I/D?

Q. In a CB amplifier the maximum efficiency could be

Q. Which among the following plays a crucial role in determining the state of dynamic system?

Q. If an antenna has a directivity of 16 and radiation efficiency of 0.9, then the gain of the antenna is:

Q. Which of the following command will reveal the damping ratio of the system?

Q. As a result of introduction of negative feedback which of the following will not decrease?

Question analytics