Q. __________ cannot increase the fatigue strength of a material.

Related MCQs

Q. Trap is used to remove __________ from steam pipe lines.

Q. The ratio of Murphree plate efficiency to point efficiency is 1 in a __________ flow model.

Q. __________ is an addition polymer.

Q. Area under the stress-strain curve upto the __________ is referred to as the modulus of resilience.

Q. Spontaneous combustion of coal on storage results due to

Q. Small furnace draught is accurately measured by an inclined tube manometer, in which the manometric liquid used most commonly is

Q. Acrylonitrile-butadiene-styrene (ABS) copolymer, which is produced by blending styrene-acrylonitfile copolymer with butadiene based elastomer, is a/an

Q. Electro-magnetic spectrum range, which is important for radiation varies from __________ microns.

Q. When vaporisation takes place through a blanketting film of gas, the phenomenon is termed as __________ boiling.

Q. Horsepower increase of a centrifugal gas compressor without altering the volumetric flow rate will __________ the gas discharge pressure.