πŸ“Š Automobile Engineering
Q. If the water level in engine is maintained low, the likely consequence could be
  • (A) Piston seizure
  • (B) Engine knocking
  • (C) Bearing deterioration
  • (D) All of the above
πŸ’¬ Discuss
βœ… Correct Answer: (D) All of the above
πŸ“Š Automobile Engineering
Q. Aluminium cylinder blocks require
  • (A) No lines
  • (B) Brass liners
  • (C) Stainless steel liners
  • (D) Cast iron liners
πŸ’¬ Discuss
βœ… Correct Answer: (D) Cast iron liners
πŸ“Š Automobile Engineering
Q. Engine starter motor is
  • (A) D.C. compound motor
  • (B) D.C. series motor
  • (C) Synchronous motor
  • (D) Single phase A.C. motor
πŸ’¬ Discuss
βœ… Correct Answer: (B) D.C. series motor
πŸ“Š Automobile Engineering
Q. Failure of an engine to start even though it turns over at normal cranking speed could be due to
  • (A) A defective cranking motor
  • (B) Defective ignition
  • (C) Run down battery
  • (D) Sticking valve
πŸ’¬ Discuss
βœ… Correct Answer: (B) Defective ignition
πŸ“Š Automobile Engineering
Q. The substance which when added in a small proportion into petrol reduces knocking is
  • (A) iso-butane
  • (B) n-heptane
  • (C) methyl nepthalene
  • (D) tetra ethyl lead
πŸ’¬ Discuss
βœ… Correct Answer: (D) tetra ethyl lead
πŸ“Š Automobile Engineering
Q. In a diesel engine the pipe carrying fuel from fuel pump to nozzle is made of
  • (A) Plastic
  • (B) Aluminium
  • (C) P.V.C.
  • (D) Steel
πŸ’¬ Discuss
βœ… Correct Answer: (D) Steel
πŸ“Š Automobile Engineering
Q. The percentage of heat released from fuel air mixutre, in an internal combustion engine which is converted into useful work is roughly
  • (A) 60 - 64 percent
  • (B) 20 - 25 percent
  • (C) 35 - 45 percent
  • (D) 10 percent
πŸ’¬ Discuss
βœ… Correct Answer: (B) 20 - 25 percent
πŸ“Š Automobile Engineering
Q. The knocking C.I engines is characterised by the sudden auto-ignition of the mixture
  • (A) at the end of the combustion process
  • (B) in the middle of combustion process
  • (C) at the very beginning of the combustion process
  • (D) none of the above
πŸ’¬ Discuss
βœ… Correct Answer: (C) at the very beginning of the combustion process
πŸ“Š Automobile Engineering
Q. The need for installing new piston rings is determined by checking
  • (A) The gap between the ends of the ring
  • (B) The clearance between cylinder and piston rings
  • (C) The clearance between piston and piston rings
  • (D) The clearance between cylinder and piston
πŸ’¬ Discuss
βœ… Correct Answer: (B) The clearance between cylinder and piston rings

Jump to