πŸ“Š Automobile Engineering
Q. Differential gear box oil is usually renewed after
  • (A) 1000 km
  • (B) 2500 - 6000 km
  • (C) 10000 - 20000 km
  • (D) 2500 km
πŸ’¬ Discuss
βœ… Correct Answer: (B) 2500 - 6000 km
πŸ“Š Automobile Engineering
Q. In commercial vehicle layouts engine is located forward, rear or under floor mainly to
  • (A) Minimize the tendency to over turn
  • (B) Reduce the weight of chassis
  • (C) Increase fuel economy
  • (D) Have better weight distribution
πŸ’¬ Discuss
βœ… Correct Answer: (D) Have better weight distribution
πŸ“Š Automobile Engineering
Q. When considerable material must be removed to clean up a cylinder bore, the cylinder should be
  • (A) Glazed
  • (B) Ground
  • (C) Honed
  • (D) Reamed
πŸ’¬ Discuss
βœ… Correct Answer: (D) Reamed
πŸ“Š Automobile Engineering
Q. Wheel base of a vehicle is the
  • (A) Distance between the front tyres
  • (B) Distance between front and rear axles
  • (C) Extreme length of the vehicle
  • (D) The combined width of rear tyres
πŸ’¬ Discuss
βœ… Correct Answer: (B) Distance between front and rear axles
πŸ“Š Automobile Engineering
Q. In a vehicle the probable cause for hard steering could be
  • (A) Low tyre pressure
  • (B) Bent wheel spindle
  • (C) Tie rod ends tight
  • (D) Any of the above
πŸ’¬ Discuss
βœ… Correct Answer: (D) Any of the above
πŸ“Š Automobile Engineering
Q. Two speed reverse gear arrangement is generally provided in case of
  • (A) Standard wagon
  • (B) Jeep
  • (C) Ambassador car
  • (D) Tractors
πŸ’¬ Discuss
βœ… Correct Answer: (D) Tractors
πŸ“Š Automobile Engineering
Q. Worn out carburettor jets are likely to cause
  • (A) More noise
  • (B) Excess fuel consumption
  • (C) Knocking
  • (D) Engine warm up
πŸ’¬ Discuss
βœ… Correct Answer: (B) Excess fuel consumption

Jump to