πŸ“Š Automobile Engineering
Q. Ignition coil is used to
  • (A) Step down voltage
  • (B) Step up power
  • (C) Step down current
  • (D) Step up voltage
πŸ’¬ Discuss
βœ… Correct Answer: (D) Step up voltage
πŸ“Š Automobile Engineering
Q. Increasing the temperature of intake air in an I.C. engine will
  • (A) increase the efficiency
  • (B) decrease the efficiency
  • (C) increase or decrease the efficiency
  • (D) Low ambient temperature
πŸ’¬ Discuss
βœ… Correct Answer: (B) decrease the efficiency
πŸ“Š Automobile Engineering
Q. The Diesel fuel pump is designed to supply fuel
  • (A) At constant quantity at all engine speeds
  • (B) In excess quantity than required by the injection pump
  • (C) Just sufficient against the demand of the injection pump
  • (D) In sufficient quantity in accordance with the engine speed
πŸ’¬ Discuss
βœ… Correct Answer: (D) In sufficient quantity in accordance with the engine speed
πŸ“Š Automobile Engineering
Q. The phenomenon by which a fuel catches fire without external flame is known as
  • (A) pre-ignition
  • (B) detonation
  • (C) ignition lag
  • (D) auto-ignition
πŸ’¬ Discuss
βœ… Correct Answer: (D) auto-ignition
πŸ“Š Automobile Engineering
Q. The knocking in C.I. engine can be prevented if the first element of the fuel and air is having
  • (A) low density
  • (B) medium density
  • (C) high density
  • (D) none of the above
πŸ’¬ Discuss
βœ… Correct Answer: (C) high density
πŸ“Š Automobile Engineering
Q. Exhaust gas leakage into the cooling system is most likely be due to
defective
  • (A) Cylinder head gasket
  • (B) Manifold gasket
  • (C) Water pump
  • (D) Radiator
πŸ’¬ Discuss
βœ… Correct Answer: (A) Cylinder head gasket
πŸ“Š Automobile Engineering
Q. Driving wheel hearings in automobiles are always
  • (A) Bush bearing
  • (B) Clad metal bearings
  • (C) Anti-friction bearings
  • (D) None of these
πŸ’¬ Discuss
βœ… Correct Answer: (C) Anti-friction bearings
πŸ“Š Automobile Engineering
Q. The level of electroyte in automobiles battery should be
  • (A) Exactly at the level of the plates
  • (B) 15 mm below the top of plates
  • (C) 5 - 10 mm below the top of plates
  • (D) 10 - 15 mm above top of plates
πŸ’¬ Discuss
βœ… Correct Answer: (D) 10 - 15 mm above top of plates
πŸ“Š Automobile Engineering
Q. As the number of cylinders on multi-cylinder engines increases the
power to weight ratio
  • (A) Has nothing to do with number of cylinders
  • (B) Decreases
  • (C) Increases
  • (D) Remains the same
πŸ’¬ Discuss
βœ… Correct Answer: (B) Decreases

Jump to