Q. When the work is done on the gases, which of the following effect is observed on the turning moment diagram?
✅ Correct Answer: (A)
formation of negative loop
Mechatronics MCQs | Page - 1
Dear candidates you will find MCQ questions of Mechatronics here. Learn these questions and prepare yourself for coming examinations and interviews. You can check the right answer of any question by clicking on any option or by clicking view answer button.
Q. If the damper is not provided and the system is in resonance, which of the following is the correct isolation factor?
✅ Correct Answer: (D)
infinity
Q. Galvanometer used should be calibrated first.
✅ Correct Answer: (B)
false
Q. Which of the following cannot be measured using potentiometer?
✅ Correct Answer: (D)
none of the mentioned
Q. Which of the following is not possible?
✅ Correct Answer: (D)
none of the mentioned
Q. Galvanometer is used for
✅ Correct Answer: (B)
indication of null position
Q. Power consumption of unknown source connected will be
✅ Correct Answer: (C)
zero ideally
Q. A potentiometer cannot be used for calibration of ammeter.
✅ Correct Answer: (B)
false
Q. Which of the following devices cannot be used potentiometer as calibrating device?
✅ Correct Answer: (D)
all of the mentioned
Q. At null position, galvanometer reading will be
✅ Correct Answer: (B)
zero
Jump to