Q. A centrifugal pump loses prime after starting. The reason of this trouble may be

  • (A) Incomplete priming
  • (B) Too high a suction lift
  • (C) Low available NPSH and air leaks in the suction pipe
  • (D) All of the above
💬 Discuss
✅ Correct Answer: (D) All of the above

Published by Ram Sharma ⭐ 193.88K Points at 10-May-2023 10:22 pm in Fluid Mechanics

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. _________ test determines the yield strength, Young's modulus of elasticity, percentage reduction in area & percentage elongation of a material.

Q. If the thermal conductivity of a wall material is independent of temperature, the steady state temperature distribution in the very large thin plane w

Q. Dry air requirement for burning 1 Nm3 of CO to CO2 may be around __________ Nm3 .

Q. Minimum tube pitch recommended for shell and tube heat exchangers is about __________ times the outside diameter of the tube.

Q. Dead zone is the

Q. Heavy water is preferred over ordinary water as a coolant, because it.

Q. Normal mercury thermometer can be used to measure a temperature of about 300°C. However, its maximum temperature measurement range can be increased u

Q. __________ is a copolymer.

Q. Alumina, silica, lime and iron oxide are the basic raw material for the manufacture of portland cement. The component of Portland cement which first h

Q. Waxes present in petroleum products

📊 Question Analytics

👁️
862
Total Visits
📽️
3 y ago
Published
🎖️
Ram Sharma
Publisher
📈
91%
Success Rate