Q. The heat recoverable from flue gases of furnaces depends on the

  • (A) Thermal efficiency of furnace
  • (B) Quantity of flue gases
  • (C) Flue gas temperature drop through the furnace
  • (D) All of the above
💬 Discuss
✅ Correct Answer: (D) All of the above

Published by Ram Sharma ⭐ 193.88K Points at 11-May-2023 08:28 am in Furnace Technology

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. With increase in temperature, the thermal conductivity of non-metallic amorphous solids

Q. Helium gas constant volume thermometer is suitable for the measurement of a temperature of __________ °C.

Q. For a thermodynamic system undergoing a process, which of the following pairs best expresses the relationship similar to that expressed by the pressur

Q. A centrifugal pump is used to pump water through a horizontal distance of 150 m, and then raised to an overhead tank 10 m above. The pipe is smooth wi

Q. Two liquids manometer is used for measuring small pressure differences in

Q. __________ cannot increase the fatigue strength of a material.

Q. Flue gas outlet temperature from the chimney of any furnace should be ideally about __________ °C.

Q. Ability of a material to __________ is indicated by its damping capacity.

Q. In furnaces operating at very high temperature (say) 1250°C, e.g. soaking pit), the maximum heat transfer takes place by

Q. A non-linear system will have __________ steady state values.

📊 Question Analytics

👁️
955
Total Visits
📽️
4 y ago
Published
🎖️
Ram Sharma
Publisher
📈
94%
Success Rate