Q. Strain type insulators are used where the conductors are

  • (A) dead ended
  • (B) at intermediate anchor towers
  • (C) any of the above
  • (D) None of the above
💬 Discuss
✅ Correct Answer: (C) any of the above

Published by Mr. Dubey ⭐ 111.54K Points at 17-Sep-2023 11:35 am in Energy Conversion

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. For minimum noise use which type of gears are used

Q. Sensible heat absorbed by 1 lb of water when it is heated from 32 to 212°F may be around __________ BTU.

Q. Which operation can correct hole location, size or alignment of the hole which is already drilled in workpiece?

Q. If w is the angular velocity of the pulley and T1 and T2 are tensions of driving and driven side then power transmitted equals

Q. In which of the following forging process poor material utilization occurs?

Q. A system having connected load of 100 kW, peak load of 80 kW, base load of 20 kW and average load of 40 kW will have a load factor of

Q. For each ton of pig iron produced in a blast furnace, the amount of ore used is approximately.

Q. In a gear having involute teeth, the normal to the involute is a tangent to the

Q. A grinding wheel is rotating at 3000 rpm. When the switch is turned off the wheel stops in 10 seconds. The uniform deceleration of the wheel was

Q. jH factor for heat transfer depends upon the __________ number.

📊 Question Analytics

👁️
401
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
97%
Success Rate