Q. Fouling factor

  • (A) Is a dimensionless quantity
  • (B) Does not provide a safety factor for design
  • (C) Accounts for additional resistances to heat flow
  • (D) None of these
💬 Discuss
✅ Correct Answer: (C) Accounts for additional resistances to heat flow

Published by Mr. Dubey ⭐ 111.54K Points at 20-Sep-2023 12:29 pm in Heat Transfer

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. The normal range of steel that is radiographed using Ir-192 is:

Q. Which of the following is the least efficient receiver of ultrasonic Energy?

Q. After the step wedge radiographs have been made, the of the image of each step is recorded on chart:

Q. A man lifts a stone weighting 300 g from the ground to a height of 2m and throws it horizontally with a velocity of 6 m/sec. The work done by the man

Q. Pick out the wrong statement.

Q. Basically D' Arsonwal movement is

Q. A rocket is fired vertically from the ground with a resultant vertical acceleration of 10 m/sec the fuel is finished in one minute and it continues to

Q. While drawing the turning moment diagram, which of the forces in not taken into account?

Q. If after some use the lower part, electrodes and beathing space of a spark plug are found coated by deposits of soot and carbon, the conclusion will b

Q. When the penumbra on a radiograph measures less than 0.5 mm (0.020 inches), the image will appear to unaided eye of the film interpreter as:

📊 Question Analytics

👁️
395
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
85%
Success Rate