📊 Industrial Engineering
Q. In case of comented carbide tools the back rake angle is positive while machining
  • (A) Mild steel
  • (B) Aluminium
  • (C) Hard steel
  • (D) Brass
💬 Discuss
✅ Correct Answer: (B) Aluminium

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. The angle of twist of shaft is

Q. When two non-parallel or intersecting but coplanar shafts are connected by gears, the arrangement is known as,

Q. Which of the following material has the best conductivity?

Q. Heat flux is the time rate of heat transfer per unit

Q. The ratio of the energy absorbed by the body to total energy falling on it is called

Q. Amount of time during which the transformer will be used for welding under normal loading condition is known as?

Q. Alum increases

Q. A mixture of gases expands from 0.03 m³ to 0.06 m³ at a constant pressure of 1 Mpa & absorbs 84 kJ of heat during the process. The chang

Q. __________binding is used to define the scope in terms of the lexical structure of a program.

Q. For 20% increase in current, the motor that will give the greastest increase in torque is ___ motor

📊 Question Analytics

👁️
144
Total Visits
📽️
2 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
91%
Success Rate