M
Explanation by: Mr. Dubey
in electromagnetic forming, many components like capacitor bank, forming coil, field shaper, conductive material etc. are used to create intense magnetic fields. this magnetic is generally produced by the discharge of capacitors into a coil, which lasts only for a few microseconds. then further processing is done to perform the metal forming.
You must be Logged in to update hint/solution
Related MCQs
Q. If viscosity of the lubricant is very low than BCN will lie in the region
Q. The compressed air flows to the actuator through
Q. Which of the following is used as indication instrument in a liquid expansion system?
Q. Which of the following is an example of a projectile?
Q. Jam nut is a locking device in which
Q. The standard frequency of electric power supply in India is
Q. Direction of feed water is done because
Q. In case of brittle material the theory of elastic failure generally applied is
Q. Dry sand cores may be required for the provision of spigot at the end section of the casting.
Q. Due to one of the reason given below,give rise to quench cracking?
Discusssion
Login to discuss.