M

Mr. Dubey • 100.64K Points
Coach

Q. Penetrants may be applied to the surface of part by :

  • (A) Spraying
  • (B) Dipping
  • (C) Pouring
  • (D) All of the above methods are acceptable
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. For continuous drying of granular or crystalline material, the dryer used is the __________ dryer.

Q. The carrier material used with strain gauges at room temperature is

Q. ‘Photoelectric effect’ refers to:

Q. Controlled atmosphere has more oxygen than carbon dioxide.

Q. Which type of pumps can give discharge even at high pressure?

Q. In a vehicle if there is no king pin offset

Q. The rotor standstill resistance and reactance of an induction motor are 0.5Ω and 2.5Ω hence the rotor impedance at 5% slip is____.

Q. Operating cost of nuclear power plant is less than thermal power plant.

Q. In locomotives, the ratio of the connecting rod length to me crank radius is kept very large in order to

Q. Through which does the even circulation of feed water is possible in Lamont boiler?

Question analytics