Q. Which method is used in large modern thermal power plants to heat feed water?

  • (A) open type heatre is used
  • (B) close type heater is used
  • (C) steam is directly taken from main turbine and used to heat it feed water
  • (D) surface type heater is used
💬 Discuss
✅ Correct Answer: (C) steam is directly taken from main turbine and used to heat it feed water
Explanation: open and contact type haters are in small power plants. such heaters recives steam from back pressure turbine. in large modern power plants heaters bleed steam from the main turbine and use it for heating of feed water.

Published by Mr. Dubey ⭐ 104.85K Points at 23-Sep-2023 07:25 pm in Power Plant Engineering (PPE)

Explanation by: Mr. Dubey
open and contact type haters are in small power plants. such heaters recives steam from back pressure turbine. in large modern power plants heaters bleed steam from the main turbine and use it for heating of feed water.

💬 Discussion

Related MCQs

Q. Which of the following have the same units?

Q. The advantage of cost plus pricing system is

Q. As differentials, heat & work would be described mathematically as

Q. An exact straight line motion mechanism is a

Q. The longitudinal wave incident angle which results in formation of a rayleigh wave is called:

Q. Which one of the following loading is considered for the design of axles?

Q. The crest diameter of a screw thread is same as

Q. Diameter to height ratio for a raschig ring is

Q. The percentage of sulphur in steel can be reduced by adding

Q. The device in the cooling system that increases the boiling point of the water in the system is called

📊 Question Analytics

👁️
823
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
90%
Success Rate