Q. Which of the following is equal to the maximum demand?

  • (A) the ratio of area under curve to the total area of rectangle
  • (B) the ratio of area under curve and number of hours
  • (C) the peak of the load curve
  • (D) the area under the curve
💬 Discuss
✅ Correct Answer: (C) the peak of the load curve
Explanation: the ratio of area under curve to the total area of the rectangle is called load factor. the ratio of area under the curve to the number of hours represents the average load. the peak of the curve represents the maximum demand.

Published by Mr. Dubey ⭐ 111.54K Points at 23-Sep-2023 07:25 pm in Power Plant Engineering (PPE)

Explanation by: Mr. Dubey
the ratio of area under curve to the total area of the rectangle is called load factor. the ratio of area under the curve to the number of hours represents the average load. the peak of the curve represents the maximum demand.

💬 Discussion

Related MCQs

Q. A A disadvantage of using a low frequency ultrasonic transducer is:

Q. Which of the following industrial process uses waste as a fuel?

Q. Which one of the following pathway represents the condensation process of the refrigerant in a refrigeration cycle?

Q. A 4 pole, 500V shunt motor has 720 wave connected conductors on its armature. The full load armature current is 60A and flux per pole is 0.03Wb. The a

Q. What is the main disadvantage of Lamont boiler?

Q. In a turning moment diagram, the variations of energy above and below the mean resisting torque line is called

Q. Entropy is a

Q. The direction of linear velocity of any point on a link with respect to another point on the same link is

Q. The below given controller circuit is a

Q. The architecture of 8051 consists of

📊 Question Analytics

👁️
869
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
92%
Success Rate